My bolt won’t close! Troubleshooting seized ejectors – rifleshooter.com

My bolt won’t close! Troubleshooting seized ejectors – rifleshooter.com



Imagine buying a new car and never changing the oil, inspecting the tires or maintaining it? This kind of neglect sounds crazy doesn’t it? Gun owners fail to perform basic maintenance.

Lack of preventive maintenance can cause a number of issues with firearms. In this post, we’ll look at a fairly common cause of problems, a seized ejector.

While ejector problems aren’t a regular occurrence, they typically manifest in one of two ways, the ejector is either stuck all the way out, or it is stuck flush with the surface of the bolt face. When the ejector is stuck out, normally a bolt won’t close on a live round, when it is stuck flush with the surface of the bolt face, the gun won’t eject.

I had an early Ruger 77 walk into the shop with a bolt that wouldn’t close on a live round. It would close on an empty chamber. Inspection of the bore found it was clean and clear of obstructions. Inspection of the spring ejector found it was solid and seized in place. This prevented the bolt from closing on a live round.

Most spring loaded ejectors are retained in place by a pin that runs perpendicular to the axis of the ejector. The pin is simply removed from the bolt body so the ejector can be removed. When I removed the ejector I immediately saw the problem, the entire ejector channel was filled with rust. The rust prevented the ejector from sliding in and out of the bolt face preventing the bolt from closing on a round.

The contents of Rifleshooter.com are produced for informational purposes only and should be performed by competent gunsmiths only. Rifleshooter.com and its authors do not assume any responsibility, directly or indirectly for the safety of the readers attempting to follow any instructions or perform any of the tasks shown, or the use or misuse of any information contained herein, on this website.

Any modifications made to a firearm should be made by a licensed gunsmith. Failure to do so may void warranties and result in an unsafe firearm and may cause injury or death.

Modifications to a firearm may result in personal injury or death, cause the firearm to not function properly, or malfunction, and cause the firearm to become unsafe.

I began by soaking the bolt face (vertically) with some Kroil. Kroil is an excellent penetrating oil that we use extensively for disassembling stuck parts.

After cleaning the ejector hole with a small drill bit, lubricating and replacing the parts the rifle was ready for service.

We’ll encounter seized extractor at the shop with some frequency. The best way to prevent this problem is to make sure you are properly lubricating and maintaining your rifle. In the event you encounter a rifle that won’t close on a round, it is an area you should inspect.





Source link

Join the Discussion

Your email address will not be published. Required fields are marked *

arrow