Removing stuck choke tubes – rifleshooter.com

Removing stuck choke tubes – rifleshooter.com



If you don’t maintain the interchangeable choke tube systems the tubes can seize into place creating a bog problem. Recently, a customer brought in a stainless steel Browning BT99 trap gun that has stuck choke tubes. In this post, we’ll take a look at one way to remove them.

Before we take a look at how to remove a stuck tube, let’s take a look at the following disclaimer:

The contents of Rifleshooter.com are produced for informational purposes only and should be performed by competent gunsmiths only. Rifleshooter.com and its authors, do not assume any responsibility, directly or indirectly for the safety of the readers attempting to follow any instructions or perform any of the tasks shown, or the use or misuse of any information contained herein, on this website.

Any modifications made to a firearm should be made by a licensed gunsmith. Failure to do so may void warranties and result in an unsafe firearm and may cause injury or death.

Modifications to a firearm may result in personal injury or death, cause the firearm to not function properly, or malfunction, and cause the firearm to become unsafe.

This BT 99 barrel had it’s tube stuck in place. It was so locked in, after he soaked the barrel in oil, the owner broke a series of wrenches attempting to remove it. He decided to bring it to me. Good move. With the fine threads on a choke system, you need to proceed with caution. Too much force and you could potentially strip the threads from the barrel ruining it. I decided that heat would be the best way to solve this problem. This was a nice gun so a torch was put of the question so I reached for my soldering iron. A soldering iron or wood burning tool always come in handy when you want to apply heat to a very specific area.

Once the choke tube was heated (I spotted some smoke rising from the Kroil burning off in the threads), I used a Briley speed wrench with the handle removed and a cheater pipe to break the tube loose.

With the choke tube out, you can see the problem, water had managed to work its way into the threads and create rust which seized the tube in place

After cleaning the threads, the tube can be reinstalled. I took the time to remind the owner to periodically lubricate the choke tubes so this doesn’t happen again.





Source link

Join the Discussion

Your email address will not be published. Required fields are marked *

arrow